Pollution Unit


Pollution Unit

Wet Collectors (Pollution Unit) For Drum Mix Plants

With the thermodrum mix process two types of emmisions may be encountered. particulates and "Blue Smoke".

The most efficient method of collecting sufficient quantities of these particulate emissions, for cleaner exhaust air is the wet type collector. These wet type collectors work on the principle of wetting the dust particules entrained in the exhaust gas stream and trapping them in water droplets which full out of the exhaust gas and are drained from the system in the form of waters sluge.

Pollution Unit

Dimensions

1 Diameter : 1630 mm .
2 Length : 5750 mm
3 Width : 1850
4 Height : 2455
5 Total Weight : --------------

Operating Data

 
DM-45 PLANT
DM-50 PLANT
Capacity
ACFM
:
10500
14500
Fan
HP
: 20 25
Waterpump
HP
: 3 3
Waterpump
Size
: 65 x 50 mm 65 x 50 mm

Water Requirements

:
CIRCULATING WATER MAKE UP
Pump Size
Pressure
GPM
Suction Pressure GPM
1¼"
50
110
4 3 5

Warning

As a safety measure, always enclose or cover setting tank with wire fencing as water temperature during operation is approximately 150°F The Setting pond shown is divided into three section by weires. The Sludge from the separator enters section (A) Where much of the sludge settles out before flowing over into section (B) By the water enters section (C) It is amply clarified for reregulation.

road construction machinery

Minimum Sludge Pond Requirements

Length
Width
Depth
GPM Gallons Area Sq. Ft. Volume Cu. Ft.
38'
19'
6'
110 33,000 700 4400

Operating Principles Of The Venture Type Wet Collectors

The exhaust gas laden with dust is removed from the drum mixer and the venture by the exhaust fan. In that Venturing. the exhaust gas passes through a water spray introduced by a spray bar multiple nozzle. The dust particles in the exhaust gas stream are "surrounded" by the water spray and moisten.

Extreme turbulence promotes the venturi narrow intimate contact of the water and dust particles to ensure through mixing. As the exhaust gas enters the separator, the dust-laden water is removed by the centrifugal action of a perforated plate skimmer. Water is drained dust ladon them out into the separator in the form of an aqueous slurry in an adjustment tank.

Shitla Road Equipment

Large Non - Clogging Nozzles

Large nozzles provide unobstructed operation and ensure minimum water maze to requirements to Collector type of risk. Wide opening recreated water nozzles without clarifying long period. Deflector water jet nozzle defect a cone spray pattern for complete wetting of the powder particles.

Efficent Weeting Action

High pressure in the exhaust gas stream ensures more efficient operation Venturing Collector with less maintenance. The exhaust gas stream more than double the rate of speed as it is forced through the venture and the turbulence creates extreme fast acceleration the exhaust gas stream, causing a highly effective mixing action between the particles and efficient of dust and spray water from the fully assembled adjustable venture having a throat actuator driven by a coating which is controlled from the operator console. This erratic "Fine tuning" to get the cleanliness efficiency optimal operating conditions of the plant.

Setting Pond For Sludge Drainage

Setting pond should be constructed of sufficient size and capacity depending on the water wet sump model used to heat the drum. The tank has a volume adjustment roughly equivalent to the amount of water passing through the manifold wet hour. The creation pond sample is divided into three sections by landfills. The sludge from the separator enters the section A, where most of the particles to settle before flowing into the next section B, When the water enters the section C, is abundantly clear to recirculation.